Resin Rockers Fast Finish Premium Fast Set Tumbler Epoxy was formulated with tumbler and resin crafters in mind. Built to perform seamlessly with most substrates and all techniques involved in tumbler making and crafts. Low odor, easy to use, high viscosity, 2-part epoxy system that cures to the ultimate crystal clear, scratch-resistant finish. Carefully engineered with UV and HALS for advanced protection against premature yellowing.

Resin Rockers Fast Finish
• FDA Compliant Food Safe
• Touchable in 2-4 Hours
• High UV Resistance
• Crystal Clear
• Super Gloss Finish
• Self-Leveling
• No Shrinking
• 100% VOC Free & Low Odor
• Advanced Formula for Strength

INSTRUCTIONS: 

Step 1: Prep
For best results, the ideal working temperature is between 75°-85°F. Work in a clean, dust-free environment with low humidity.

Step 2: Measure
Pour equal amounts of resin and hardener into a mixing container.

• 20oz Tumbler – 20mL
• 30oz Tumbler – 30mL
• 40oz + Tumbler – 40 mL

Step 3: Mix
Stir thoroughly for 1-3 minutes, continuously scraping the sides and bottom of the mixing container. Transfer into a new, clean mixing container and mix again for another 1-2 minutes.

Step 4: Pour
Pour immediately onto your tumbler. Spread epoxy evenly. If bubbles appear, use a propane torch held 6 inches away and sweep rapidly until bubbles disappear.

Step 5: Set
For the best curing results, room temperature should remain between 75°-85°F. Cured to the touch in 2-4 hours, fully cured in 72 hours. Wipe down your mixing tools before the resin dries. Uncured resin can be cleaned up with acetone.

How to store my epoxy:
Keep at room temperature dry place. To prevent oxidation, be sure to seal the top air tight. You can also put press n seal wrap under the lid if you will not be using your epoxy for some time to prevent oxygen exposure.

PRECAUTIONS: Keep out of reach of children. Prior to use, refer to the SDS. Wear protective nitrile gloves and appropriate eye protection. Avoid inhalation; it is highly recommended to wear a respirator with every use. After handling, thoroughly wash hands.

FIRST AID TREATMENT: If in eyes, rinse with water for several minutes. If wearing contact lenses, remove them before rinsing. If eye or skin irritation occurs, discontinue use and seek medical advice. IF ON SKIN: Wash with plenty of water. Wash contaminated clothing before reuse. Ensure proper disposal and refrain from releasing uncured product into the environment.

WARNING: IRRITATING TO SKIN AND EYES. MAY CAUSE AN ALLERGIC SKIN REACTION.

CONFORMS TO ASTM D-4236

*All epoxy yellows over time. Fast Set epoxies may yellow faster than art formulas.