Resin Rockers Perfect Finish Epoxy Resin was formulated with the tumbler artist and fine artist in mind. It is built to perform seamlessly with most substrates and all techniques involved in tumbler making and canvas coating. Perfect Finish is a low odor, easy to use, high viscosity, 1:1 ratio, 2-part epoxy system that cures to the ultimate crystal clear, scratch-resistant finish. Carefully engineered with UV and HALS for advanced protection against premature yellowing with a long working time and a seamless finish. You will not find better UV protection than with Perfect Finish.
Perfect Finish can be used on all types and variations of tumblers including glitter vinyl, micas, pigment flakes, alcohol inks and more to create that one-of-a-kind piece AND to add a rock-hard topcoat. It can also be used to coat UV Resin tumbler applications such as drips and embellishments.
This formula is the best in its class when it comes to top-coating fine artwork and doming resin pieces. The UV protection is unmatched. It can also be used to topcoat tables and bar tops.
EASY Application:
Step 1: Prep
For best results, the ideal working temperature is between 75°-85°F. Work in a clean, dust-free environment with low humidity.
Step 2: Measure
Pour equal amounts of resin and hardener into a mixing container.
Step 3: Mix
Stir thoroughly for 1-3 minutes, continuously scraping the sides and bottom of the mixing container. Transfer into a new, clean mixing container and mix again for another 1-2 minutes.
Step 4: Pour
Pour immediately onto your tumbler. Spread epoxy evenly. If bubbles appear, use a propane torch held 6 inches away and sweep rapidly until bubbles disappear. One pass should suffice.
Step 5: Set
For the best curing results, room temperature should remain between 75°-85°F. Cured to the touch in 24 hours, fully cured in 72 hours.
Step 6: Clean up
Wipe down your mixing tools before the resin dries. Uncured resin can be cleaned up with acetone or alcohol. Baby wipes work well also.
How to store my epoxy:
Keep at room temperature dry place. To prevent oxidation, be sure to seal the top air tight. You can also put press n seal wrap under the lid if you will not be using your epoxy for some time to prevent oxygen exposure.
CONFORMS TO ASTM D-4236
FIRST AID TREATMENT: If in eyes, rinse with water for several minutes. If wearing contact lenses, remove them before rinsing. If eye or skin irritation occurs, discontinue use and seek medical advice. IF ON SKIN: Wash with plenty of water. Wash contaminated clothing before reuse. Ensure proper disposal and refrain from releasing uncured product into the environment.
WARNING: IRRITATING TO SKIN AND EYES. MAY CAUSE AN ALLERGIC SKIN REACTION.
